Motogadget m-Blaze Pin (Pair)

$98.00$154.50

The motogadget m-Blaze Pins are extremely small and super bright turn signals.

Options:
Pre-Wired – Allows for plug-and-play installation – See more below
Relay/Resistors – Control flash rate – See more below

SKU: N/A Category:

Description

The motogadget m-Blaze Pins are extremely small and super bright turn signals. The IntesiLED SYSTEM enables an extremely bright and very evenly distributed light. High-quality turn signals in a very small form factor. There is a small directional reflector in the design of the lens but the signal can be seen from the “backside” as well. The aluminum casing is CNC machined and anodized black. Has built-in electronic voltage conditioning by IC controlled constant power source.

What’s Included:

  • (2) Black Turn Signal w/M8 Thread and Serrated Flange Nut
  • 39″/100cm Wire Length
  • Instructions
  • (4) Crimp Connections

Specs
Total length with thread: 38,5 mm
Length without thread: 19,5 mm
Biggest diameter: 16 mm
Cable length: about 100 cm
Weight: about 12 g
Installation: M8 threaded bolt

Power consumption: about 3 Watt

The turn signal can be installed like any other LED turn signal with load resistors.

Options:
Pre-Wired – Allows for plug-and-play installation. These signals are 2-wire and only cover the turn signal function! If your model has 3 wire signals (running lights) additional wiring may be required. Install adapters allow for installation in stock signal location. Inline bullet connectors to pass through 8mm nut and connectors to match your factory harness.
Relay/Resistors – Eliminate “hyper blinking” by adding either inline resistors or swapping out your flasher relay. (see below for known compatibility). Typically only one resistor per side is necessary and can be installed inline either on the front or rear turn signals. If you already have an integrated LED tail light, chances are you already have resistors or the correct flasher relay.

Known Relay & Resistor Compatibility:
Typically only one resistor per side is necessary and can be installed in-line either on the front or rear turn signals. If you already have an integrated LED taillight, chances are you already have resistors or the correct flasher relay. Only select pre-wired resistors if you are also selecting pre-wired turn signals.

Triumph
2013-2016 Street Triple – 2 Prong Relay may be needed
2007-2012 Street Triple – 2 Prong Relay
2005-2010 Speed Triple – 3 Prong Relay
2011-2015 Speed Triple – 2 Prong Relay may be needed
2016+ (Water Cooled) Bonneville, Thruxton, Street Twin, Street Scrambler, Street Cup – None Needed (signal flash rate controlled from the display)
2012-2015 (VIN = 521669+) Bonneville, Thruxton, Scrambler – 2 Prong Relay
Pre-2012 Bonneville, Thruxton, Scrambler – 3 Prong Relay

Ducati
Classic Monsters – 3 Prong Relay
696/796/1100 – Resistors needed on front OR rear
797/821/1200 & Scrambler – Resistors (If upgrading front AND rear to LED then no resistors are needed)

Yamaha
XSR and FZ/MT – 2 Prong Relay

BMW
RnineT – North American models, resistor needed or take the bike to a dealer for LED coding. All others, none needed

Additional information

Weight .25 lbs
Dimensions 4 × 3 × 1 in

Reviews

There are no reviews yet.

Be the first to review “Motogadget m-Blaze Pin (Pair)”

This site uses Akismet to reduce spam. Learn how your comment data is processed.